Dual ESP32 Wi-Fi Development Board designed by AWOK

FEATURES

• This board has 2 ESP32-WROOM chips on it.
• GPS can be toggled on and off for both ESP32 chips via the dip switches located on the back of the board.
• The GPS can be ran simultaneously to both chips (by default all switches will be flipped to the on position)
  
• This board is intended to monitor your network and should not be used to transmit. 
• This Development board does not include firmware, the intention of this device is to provide you with hardware to program and develop your own firmware. There are many different firmware's that an ESP32 can run and are available online so please research which one suits your needs the best.
• One ESP32 controls the screen, the other can be used via CLI or via the GPIO pins

WHATS INCLUDED

• 1x Dual Touch V3 PCB
• 1x Case (Clear) with option SMA antenna mount hole
• 2x External 2.4ghz antenna
• 1x INTERNAL ceramic GPS antenna *NOT EXTERNAL

WHATS NOT INCLUDED

• External GPS antenna
  
• Firmware

UPDATES

• STL files for printing your own case can be found here.

DISCLAIMER

• The hardware purchased from this site is for educational and experimental purposes only and is not meant for any illegal activity or purposes. I do not condone illegal activity and strongly encourage keeping usage to legal or valid educational and experimental uses allowed by law on your own equipment and or equipment you have permission to experiment on. Please check your local State and or Country laws before using any products purchased from AWOK Dynamics. Thank you.
  
  

*If your device starts randomly scrolling through menus, check the inside of the front bezel. Make sure the edges are smooth and there’s no extra plastic sticking out. Sometimes the molding process leaves small imperfections that can put pressure on the screen. If you notice any sharp or leftover plastic, just use something flat or sharp to carefully trim it off. I do my best to catch and fix these flaws before shipping, but a few can slip through.