INSTRUCTIONS

Desired temperature for work environment:  70-85 degrees,

Clean the application and surrounding areas prior to applying.  We recommend the following items for installation:

• Microfiber
• Detailing Spray or glass cleaner
• Soapy Water (StickerFab Application Fluid recommended)
• Squeegee (soft edge)
• Heat Gun or Hair Dryer

Make sure there is no wax on the lens.  We highly recommend using StickerFab Application Fluid.  A cup of water and single drop of dish soap is acceptable but not preferred.  Clean your hands and wet your fingers.  This will prevent fingerprints from transferring to the back of the PPF.  Then you can wet the back of the PPF film.  This allows you to slide the vinyl around into the right position.  Once you have found that position, use your fingers to push out the soapy water.  Allow to dry.  LOW heat can be used to dry out the vinyl quicker and make it adhere around the corners better.