The OEM 2nd and 3rd Gen Tacoma bump stops are essentially hard rubber pucks that provide zero damping, sending the full force of the impact directly into your spine and chassis. The Timbren Active Off-Road Bumpstops replace those rigid factory units with a progressive natural rubber spring, turning a violent bottom-out into a smooth, controlled transition.

Key Features

• Progressive Rate Damping: Unlike the brick wall feel of OEM stops, these absorb energy incrementally, significantly reducing the harshness of suspension bottoming.
• Zero Maintenance: Get the performance benefits of a hydraulic bump stop without the rebuild intervals, nitrogen charges, or leaking seals.
• Frame Protection: By absorbing energy rather than deflecting it, you reduce stress on your Suspension components and frame mounting points.
• Complete Kit: This isn't just a rubber puck; it includes the necessary beefy hardware to ensure your leaf pack stays secured under load.
• Improved Control: Helps maintain vehicle stability during high-speed off-road sections or when carrying heavy Recovery gear and camping equipment.

What’s Included

• (2) Patented Aeon® bump stops
• (2) Laser-cut, powder-coated mounting brackets
• (2) Steel Cups
• (4) High-strength Zinc-plated U-bolts
• (2) U-Bolt brackets
• (1) Complete hardware kit (washers and nuts)
  

Pro Tip: Because this kit replaces the factory strike plate on top of your leaf spring, it includes longer U-bolts to account for the thickness of the Timbren bracket. Do not reuse your old U-bolts. Once you torque these down after the first trail run, check them again. U-bolts often need a quick re-snug after they've had a chance to settle.