This Bonaire Vulcan Gas Heater Fan Motor Deluxe is a direct replacement for 30-40MJ models. It's essential for maintaining proper airflow and heat distribution within the unit, especially when the original motor starts playing up or just stops.

Keeping that warm air moving smoothly is crucial, especially during those chilly Australian winters. Replacing a faulty fan motor ensures your customer's heating system runs reliably, avoiding uncomfortable call-backs.

Best For

• HVAC service technicians working on ducted gas heating.
• Licensed gas fitters and appliance repair specialists.
• Competent DIY owners maintaining their Bonaire Vulcan Deluxe systems.

Compatibility

This fan motor is specifically designed for Bonaire Vulcan Deluxe gas heaters. It suits both the 30MJ and 40MJ capacity units only. The Bonaire Part Number for this component is 4720159SP. If you're running a different model, check fittings and specs before ordering.

Features

• Direct OEM Replacement: Matches Bonaire PN 4720159SP for perfect fitment and performance.
• Optimal Airflow Restoration: Ensures efficient heat distribution throughout the ducted system.
• Reliable Operation: Built to provide consistent performance for 30MJ and 40MJ Vulcan Deluxe units.
• Straightforward Installation: Designed for an easy swap-out by qualified personnel.

What's in the Box

• 1 x Bonaire Vulcan Gas Heater Fan Motor Deluxe (CTSPS4720159SP)

Using It on the Job

1. Always isolate power to the gas heater at the main switchboard and perform a lockout/tagout procedure before starting any work.
2. Access the existing fan motor compartment, typically by removing the appliance panels or shrouds.
3. Carefully disconnect electrical wiring, taking a clear photo or noting the position and colour of each wire for accurate reconnection.
4. Remove the mounting screws or bolts securing the old fan motor and carefully extract it.
5. Install the new Bonaire fan motor, ensuring it seats correctly and all mounting hardware is tightened firmly.
6. Reconnect all electrical wiring as noted earlier. Restore power and confirm proper fan operation without unusual noises before finalising the job.

Limitations & Safety Notes

• This fan motor is exclusively for Bonaire Vulcan Deluxe 30-40MJ gas heaters.
• Work on gas appliances in Australia requires a current gas fitting licence or equivalent qualification.
• Always disconnect mains power and implement lockout procedures before servicing electrical components.
• Ensure all electrical connections are secure to prevent potential hazards.

Tradie Pro Tip

Before you even touch the old motor, take a clear photo of the wiring. It saves a lot of head-scratching when you're hooking up the new one, especially if the old wires are faded or the schematic isn't clear.

Pair With

Pair with a new ignitor or flame sensor for a full service on older units, and always have a general-purpose multimeter on hand for efficient troubleshooting.