Removes stubborn stains such as iron powder, insects, bird droppings, paint mist, tar, pitch, and brake dust from the car body that are difficult to remove with car washes or cleaners, and removes stains from painted surfaces. Leaving iron powder unattended is the cause of rust and aging! Work faster than using iron powder! Work once a month to keep your body smooth! Revitalize with hot water and use repeatedly!

You can work in wet conditions. The back side of Turbo Rub can be used as a microfiber cloth for car washing. [Work procedure] 1. Wash off dirt, sand, dust, etc. 2. Gently rub the body with the "rubber polymer surface" with plenty of shampoo water. *Please use pure shampoo. (Do not contain abrasives or coatings.) 3. By repeating step (2), the rubber polymer will remove the iron powder. 4.If a large amount of iron powder is attached, it may not be possible to remove it in one operation. Repeat the process while checking the adhesion of the rubber polymer. *Please use "Regular" for stubborn stains. Please note that rubbing too hard may cause small scratches. 5. After work, please check the attached "Iron Powder Confirmation Sheet". (You can check whether there is any roughness by inserting your finger into the sheet and gently tracing the body.) 6. Rinse off the shampoo water with sufficient water. 7. After completing step (6), finish with wax or coating agent. [Caution] ■Please do not use it for any other purpose. ■Do not use during strong winds as sand, dust, etc. may cause scratches. ■Do not use on deteriorated painted surfaces. ■Please do not use it under the hot sun. ■Do not use on unpainted parts of clear paint such as license plates as the paint may peel off. ■If you rub too hard, you may get scratches or scales on the body, so please use plenty of shampoo water to slide the rubber polymer on. ■Continuing to work with the rubber polymer surface dirty may cause scratches. ■In rare cases, polishing scratches may appear. In that case, please remove it with liquid compound or cleaner. ■Please try it on an inconspicuous part of your car before use. ■Please check with the contractor before using a car that has been coated. [Storage method] After use, be sure to soak it in lukewarm water for about 30 minutes, spit out the iron powder, and let it air dry. If there is severe iron powder adhesion, please soak it in hot water of about 50 to 60 degrees for about 30 minutes. After thoroughly drying the rubber polymer surface to prevent any substances from adhering to it, store it away from direct sunlight or high temperatures.


Manufacturer: ABA(ABA)
Brand: ABA(ABA)
Model name: SG-109
Package size: 23.8 x 17.8 x 2.8 cm; 90 g
Product model number: ‎SG-109
Certification: ‎None
Product weight: ‎90 g