This Bonaire Control Board (part number CTSPS5441201SP) is a direct replacement for faulty PCBs in Bonaire MB3 Series 3 Star ducted gas heaters. It's designed to restore proper function to your heating system, making sure it fires up reliably when the mercury drops.

A common call-out during winter, a dead control board can leave homeowners in the cold. Having the right replacement on hand means you can get the heat back on fast without needing to chase down parts. It's a critical component for keeping Australian homes warm.

Best For

• HVAC service and maintenance technicians
• Gas heating specialists
• Competent DIY owners maintaining their Bonaire ducted gas heater

Compatibility

This control board is specifically for Bonaire MB3 Series 3 Star ducted gas heating units. The manufacturer's part number is Bonaire PN 5441201SP. It's crucial to confirm your existing unit's model and star rating to ensure a correct fit and proper operation. If you're running a different model, check fittings and specs before ordering.

Features

• Genuine Bonaire replacement part, ensuring proper fit and function.
• Designed for MB3 Series 3 Star gas heater models.
• Direct replacement for Bonaire Part Number 5441201SP.
• Restores full control and operation to your heating system.

What's in the Box

• 1 x Bonaire Control Board MB3 3 Star Model (CTSPS5441201SP)

Using It on the Job

1. Isolate Power: Always begin by cutting power to the heating unit at the main switchboard. Apply lockout/tagout procedures as necessary to prevent accidental re-energisation.
2. Access Board: Locate and carefully open the control panel or compartment housing the existing PCB within the gas heater cabinet.
3. Disconnect Old Board: Take photos of wiring if unsure, then meticulously disconnect all electrical connections and remove mounting screws holding the old control board in place.
4. Install New Board: Position the new Bonaire Control Board (CTSPS5441201SP) and secure it with its mounting hardware. Reconnect all wiring harnesses firmly, ensuring each connection is correctly seated.
5. Test Operation: Restore power to the unit. Follow manufacturer start-up procedures and test the heater through various modes to confirm proper operation and fault-free performance.

Limitations & Safety Notes

• Installation of this component should only be undertaken by a qualified gasfitter or HVAC technician experienced with gas heating appliances.
• Always ensure the main power supply to the appliance is isolated and secured before performing any service work.
• Verify that this replacement board (CTSPS5441201SP) precisely matches the model and star rating of your existing Bonaire MB3 3 Star gas heater.
• Refer to the Bonaire service manual for specific installation instructions and safety protocols for your particular unit.

Tradie Pro Tip

Before you even pull the cover, double-check your diagnostic codes. Sometimes what looks like a board fault is actually just a pressure switch or ignitor acting up. Replacing the right part the first time saves everyone hassle and money.

Pair With

Consider pairing this control board with new gas pressure switches or an ignitor if you're undertaking a broader service on an older Bonaire heating unit. You might also find replacement capacitors useful for other electrical components.