Every HVAC system relies on the small parts working right, and that includes your Brivis condensation hose. This genuine replacement part is essential for managing the condensate drain, stopping water leaks and ensuring your Brivis ducted heater or evaporative cooler runs clean.

I've seen enough water damage from a dodgy or blocked drain line to know it's worth getting sorted right with the correct part.

Best for: Maintaining Brivis ducted gas heaters and evaporative coolers that use part number BS80008338.

Compatibility

This is a genuine Brivis condensation hose designed specifically for Brivis heating and cooling units. It replaces Brivis part numbers B008338 and 80008338. If you're running a different model, check fittings and specs before ordering.

Features

• Genuine Brivis replacement part (BS80008338 / B008338).
• Designed for proper condensate drainage from Brivis units.
• Helps prevent water leaks and blockages in your HVAC system.

What's in the Box

• 1 x Brivis Condensation Hose MPS (BS80008338)

Using It on the Job

1. Always isolate power to the unit at the main switchboard before starting any work.
2. Locate the existing condensation hose and drain pan on your Brivis unit.
3. Carefully disconnect the old hose, checking for any blockages or sediment in the drain pan. Clean the pan if needed.
4. Install the new Brivis condensation hose, ensuring a snug fit at all connection points and correct routing to the drain.
5. Check for kinks, tight bends, or sags in the hose that could create water traps or restrict flow.
6. Restore power and test the unit's operation, ensuring condensate drains freely without leaks or overflows.

Limitations & Safety Notes

• This part is only for compatible Brivis heating and cooling systems (B008338 / 80008338).
• Ensure proper routing and adequate fall for effective gravity drainage to prevent overflows.
• Always isolate power before attempting any maintenance or replacement work on HVAC equipment.
• Follow all Australian standards and Safe Work guidance when working on heating or cooling systems.

Tradie Pro Tip

Always give your new condensation hose a good visual check after installation, especially for any low spots where water can sit and encourage algae growth. A clean, clear run means less call-backs.

Pair With

Pair with a good quality hose clamp and some anti-algae drain pan treatment to keep your Brivis system running smoothly and prevent future blockages.