Hydro Axis heat mats are high quality, flexible heat mats with a very smooth surface for better heat transfer. This helps to make them more energy efficient than their cheaper counterparts.

These heat mats are designed to warm the root area by up to 10 °C above ambient temperature, which will increase the success rate of seedlings and cuttings.

They are 50cm wide and come in three different lengths: 25cm, 50cm and a massive 120cm!

They are very easy to clean and no need to worry about spills, as they are IP64 water resistant.

Unlike many cheaper heat mats on the market, our Hydro Axis heat mats are fully RCM certified, ensuring compliance with New Zealand and Australian electrical safety standards for added peace of mind and insurance compliance.

For better results, place the heat mat on an insulated surface, like wood, cardboard or foam board. Be careful with varnished wood surfaces, as this can cause discolouration.

If you are looking for more control over the temperature of your heat mat, add a Hydro Axis heat mat thermostat to set a precise temperature.

Specifications (small)

• 50cm x 25cm (fits one prop box)
• 230V~ 50Hz - 20 Watt
• Cord length 1.8m
• IP64 Water resistant
• RCM Certified
• Compatible with any thermostat
• Warranty 1 year

Specifications (medium)

• 50cm x 50cm (fits 2 prop boxes)
• 230V~ 50Hz - 45 Watt
• Cord length 1.8m
• IP64 Water resistant
• RCM Certified
• Compatible with any thermostat
• Warranty 1 year

Specifications (large)

• 50cm x 120cm (fits 4-5 prop boxes)
• 230V~ 50Hz - 100 Watt
• Cord length 1.8m
• IP64 Water resistant
• RCM Certified
• Compatible with any thermostat
• Warranty 1 year

Please note

When you order multiple items: Retail boxes will be shipped out separately and may incur an extra shipping cost. Heat mats without retail box will be sent rolled up to save space and will not incur an extra shipping cost.

Due to their size, the larger heat mats may arrive with some wrinkling, this will smooth out with time and use. You can speed up this process by plugging in your heat mat, leave it to warm up for about 30 minutes. Then unplug it, roll it up while still warm with the top side down (printing on the outside of the roll) and leave it to cool down for a while.